PRODUCT DETAILS
MultiPlus 12/1200 - 50-16 - 120V - VE. Bus
The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology, and a high-speed AC transfer switch in a single compact enclosure. Next to these primary functions, the MultiPlus has several advanced features, as outlined below.
Parallel Operation and Three-Phase Capability
Up to six Multis can operate in parallel to achieve higher power output. In addition to parallel connection, three units can be configured for three-phase output.
PowerControl - Dealing with Limited Generator, Shore Side or Grid Power
With the Multi Control Panel, a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist - Boosting the Capacity of Shore or Generator Power
This feature takes the principle of PowerControl to a further dimension. It allows MultiPlus to supplement the capacity of the alternative source. Where peak power is often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load is reduced, the spare power is used to recharge the battery.
Four Stage Adaptive Charger and Dual-Bank Battery Charging
The main output provides a powerful charge to the battery system using advanced ‘adaptive charge’ software. The software fine-tunes the three-stage automatic process to suit the condition of the battery and adds a fourth stage for long periods of float charging. The adaptive charge process is described in more detail on the Charger datasheet and Victron's website under Technical Information. In addition to this, the MultiPlus will charge a second battery using an independent trickle charge output intended for a main engine or generator starter battery.
High Start-Up Power
It is needed to start high-inrush loads such as power converters for LED lamps, halogen lamps, or electric tools.
Search Mode
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode, the Multi, when operating in inverter mode, is switched off in case of no load or very low load and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
Programmable Relay
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energize in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Remote On/Off/Charger On
Three pole connector.
On-Site System Configuring, Monitoring, and Control
After installation, the MultiPlus is ready to go. Some settings can be changed with DIP switches. 500/800/1200VA models: remote switch/battery charge voltage/inverter frequency/search mode. 1600/2000VA models: battery charge voltage/search mode. For more settings use VE-Config or the VE. Bus Smart dongle.
Remote Configuring and Monitoring
Install a Cerbo GX or other GX product to connect to the internet. Operational data can be stored and displayed on Victron's VRM (Victron Remote Management) website, free of charge. When connected to the internet, systems can be accessed remotely, and settings can be changed.
Specifications:
- PowerControl: Yes
- PowerAssist: Yes
- Transfer Switch (A): 16
Inverter Specifications:
- Input Voltage Range (V DC): 9,5 – 17 V
- Output voltage: 120 VAC, ± 2%
- Continuous Output Power at 25°C (VA): 1200
- Continuous Output Power at 25°C (W): 1000
- Continuous Output Power at 40°C (W): 900
- Continuous Output Power at 65°C (W): 600
- Peak Power (W): 2400
- Maximum Efficiency (%): 93
- Zero Load Power (W): 13
- Zero Load Power in Search Mode (W): 4
Charger Specifications:
- AC Input voltage range 95 - 140 V
- AC Input Frequency range: 55-66Hz
- Charge Voltage Absorption (V DC): 14,4
- Charge Voltage Float (V DC): 13,8
- Storage Mode (V DC): 13,2
- Charge Current House Battery (A): 50
- Charge Current Starter Battery (A): 1
- Battery Temperature Sensor: Yes
General Specifications:
- Programmable Relay: Yes (1x)
- Protection: a - g
- VE.Bus Communication Port: For parallel and three-phase operation, remote monitoring and system integration (RJ45-splitter ASS030065510 needed for 500 / 800 / 1200 VA models)
- Remote On-Off: On/off/charger only
- DIP Switches: Yes
- Internal DC Fuse: 200A
- Operating Temperature Range: -40 - +65°C / -40 to 150°F (fan-assisted cooling), Humidity (non-condensing) max 95%
Enclosure Specifications:
- Common Characteristics: Material & Color: aluminum (blue RAL 5012) / Protection category: IP 21
- Battery-Connection: 35 mm²
- AC-Connection: G-ST18i connector
- Weight: 8.2 kg (18.1 lbs)
- Dimensions (H x W x D): 406 x 250 x 100 mm / 15.98 x 9.84 x 3.94 in.
Standards:
- Safety: EN-IEC 60335-1, EN-IEC 60335-2-29, EN 62109-1
- Emission, Immunity: EN 55014-1, EN 55014-2, EN-IEC 61000-3-2, EN-IEC 61000-3-3, IEC 61000-6-1, IEC 61000-6-2, IEC 61000-6-3
- Automotive Directive: ECE R10-5
- Protection: Output short circuit, Overload, Battery voltage too high, Battery voltage too low, Temperature too high, 230VAC on inverter output, Input voltage ripple too high
- Non-linear load, crest factor 3:1
- Up to 25°C ambient
- Programmable relay which can be set for: general alarm, DC under voltage or generator start/stop signal function. AC rating: 4 A at 120 V DC rating: 4 A up to 35 V, 1 A up to 60 V
- For parallel and three-phase operation an RJ45-splitter ASS030065510 is needed.
- Select remote behaviour, battery charge voltages and/or search mode
Quick Guide (pdf)
Owner's Manual (pdf)
Brochure (pdf)
Victron MultiPlus 12/1200 - 50-16 - 120V - VE. Bus [PMP122120100]
The vast majority of our products come from the United States, which explains our delivery times consequently between 1 and 4 weeks. It is possible to receive your parcels in express (7 working days) for some products, you will find all the information on the delays and on the costs according to each product on the product page.
SHIPPING POLICY
1. Costs and shipping options Shipping costs vary according to the country of the recipient. Our products are shipped from the USA to France, and we dispatch all our orders from France. The final dispatch shipping costs will be displayed during the purchase of your order (before payment) according to each country and the delivery options chosen.
2. Delivery time Most of our products come from the USA. Therefore, we have a preparation time of 1 to 2 weeks to receive the goods at our French office at 7 rue Alaric II 31000 Toulouse for final shipment. It takes 1 to 3 weeks from the order date to the delivery date. It is possible to receive your parcels in accelerated shipment for certain products in stock at our French office. You will be able to see the exact delivery times, shipping costs, and whether the product(s) you have chosen is (are) eligible for express shipping when you place your order. This may vary depending on your delivery address.
REFUND POLICY
We have a 30-day return policy, which means you have 30 days after receiving your item to request a return.
To be eligible for a return, your item must be in the same condition that you received it, unworn or unused, with tags, and in its original packaging. You’ll also need the receipt or proof of purchase.
To start a return, you can contact us at info@euroboatparts.com If your return is accepted, we’ll send you a return shipping label, as well as instructions on how and where to send your package. Items sent back to us without first requesting a return will not be accepted.
You can always contact us for any return question at info@euroboatparts.com.
Damages and issues
Please inspect your order upon reception and contact us if the item is defective, damaged or if you receive the wrong item, so that we can evaluate the issue and make it right.
Refunds
We will notify you once we’ve received and inspected your return, and let you know if the refund was approved or not. If approved, you’ll be automatically refunded on your original payment method. Please remember it can take some time for your bank or credit card company to process and post the refund too.
Return procedure
When you contact us to request a return, we will send you a prepaid return label with which you can return your package. This will be a label from your local post office or DHL depending on your location. You then just have to follow the procedure that will be indicated to you. Once we receive your return, we will send you your refund using the same method as your payment, or we will send a new product depending on your request.
Our Products are 100% Original and comes directly from the Manufacturer or Reseller.
We're a top rated seller per our ratings on eBay / Google / Amazon / Trustpilot.
We offer 1 YR Warranty for Brand New Items and 90 Days Warranty for Refurbished.
We have Qualified Personnel from all Over the World.
Our Locations are in the USA / France.